Kategorien durchsuchen
Entdecken
Fiverr Pro
Deutsch
$
USD
I will design custom mcu pcbs in kicad
Sri Lanka
Ich spreche Singhalesische Sprache, Englisch, Japanisch, Tamil
4 Aufträge abgeschlossen
Embedded Systems Engineer Specializing in Firmware and PCB Design
Hi, I’m Prageeth, I develop embedded firmware and design custom MCU PCBs for industrial, robotics and electronic projects. My work includes C/C++ firmware, STM32 peripherals, CAN bus communication, Ki...
Über diesen Service
I design practical 2-layer MCU and embedded-control PCBs in KiCad for prototypes and small products.
WHAT I OFFER
- Schematic capture (Standard/Premium)
- PCB layout and editable KiCad project files
- BOM, Gerber and drill files (by package)
- 2D/3D board views
SUITABLE PROJECTS
- MCU/module-based boards with basic sensors
- GPIO, UART, I²C, SPI and connectors
- Simple regulated power and low-speed interfaces
PLEASE NOTE
- Basic package requires your complete schematic.
- Firmware, fabrication, assembly and physical testing are not included. Firmware can be discussed separately through my embedded firmware gig.
- RF/antenna design, mains voltage, high-current motor drivers, complex power electronics, DDR, Ethernet, controlled-impedance/high-speed designs and 4-layer boards need prior review and a separate quote.
BEFORE ORDERING
Please provide the board's purpose, exact MCU/part number, I/O list, power requirements, dimensions, connector details, and any available schematic, datasheet or reference design. Message me first if you need a circuit developed from scratch or are unsure which package fits.
Dateiformat:
Gerber
•
STEP
•
SCH
•
•
Andere
Software:
KiCad
Interface:
UART
•
USB
•
SPI
•
I2C
Mein Portfolio
Meine weiteren Dienstleistungen im Bereich Elektrotechnik
FAQ
What types of PCBs do you design?
I focus on straightforward 2-layer MCU and embedded-control boards with basic sensors, connectors, GPIO, UART, I²C, SPI and simple regulated power.
Can you design a PCB from just an idea?
A simple design may be possible with clear requirements. Please contact me first so I can review the circuit scope and recommend a package or custom offer.
Do I need a completed schematic?
Yes, for Basic. Standard and Premium can include schematic capture for suitable, straightforward MCU circuits.
Do your packages include firmware?
No. Firmware development is offered separately through my embedded firmware gig or a separate custom offer, after reviewing the hardware and requirements.
What files will I receive?
Depending on the package, you may receive editable KiCad project files, schematic, BOM, Gerber files, drill files and board views.
Do you manufacture or assemble the PCB?
No. Fabrication and assembly are not included. I provide the agreed design files for you to send to a PCB manufacturer.
Will you physically test the finished board?
No physical testing is included. I can run appropriate KiCad ERC/DRC checks, but these do not guarantee that a board will work after fabrication.
Do you design 4-layer, RF or high-speed PCBs?
These are outside the standard packages. Contact me first for a feasibility review; I will only accept work that fits my capabilities.
What counts as a revision?
A revision covers reasonable changes to the agreed scope. New features, a changed MCU, major circuit changes or a redesign may require a custom quote.
Can you take robotics-related PCB projects?
This gig focuses on embedded electronics, not robotics software. A simple robot-controller PCB may fit after review. Robotics firmware would be discussed separately.
