Kategorien durchsuchen
Entdecken
Fiverr Pro
Deutsch
$
USD
I will design ardupilot flight controller pcb for drone and uav hardware imu sensor pcb
Pcb design
I am a experienced Hardware design engineer. I have good experience with PCB Layout and I have been working as a PCB Layout Designer for many years. I am a hard worker and enjoy working at all critica...
Über diesen Service
ARDUPILOT FLIGHT CONTROLLER PCB & UAV HARDWARE
A reliable flight controller starts with the right hardware architecture: MCU, IMU, barometer, GPS interfaces, power management, communication buses and actuator outputs all need to work together within the PCB's size and electrical requirements.
I will design ArduPilot flight controller PCBs, drone electronics, UAV autopilot hardware and custom flight control boards for your project.
WHAT I WILL PROVIDE:
- ArduPilot compatible flight controller PCB
- Custom drone flight controller
- UAV autopilot PCB
- STM32 MCU integration
- IMU / accelerometer / gyroscope interfaces
- Barometer integration
APPLICATIONS:
- Multirotors
- Fixed wing UAVs
- VTOL aircraft
- Autonomous drones
WHY CHOOSE ME?
I focus on flight controller architecture, sensor integration, embedded hardware, communication interfaces and practical PCB layout for compact UAV systems.
I can work from your existing schematic, block diagram, component list, reference board or project concept and develop the PCB around your required hardware.
Have an ArduPilot or UAV project? Send me your requirements, board dimensions or reference design and let's discuss your flight controller hardware.
FAQ
Can you design an ArduPilot flight controller PCB?
Yes. I can develop custom hardware around your ArduPilot project requirements.
Can you design a complete flight controller?
Yes. I can design the PCB hardware including MCU, sensors, power, communication interfaces and actuator outputs.
Can you integrate IMU sensors?
Yes. Accelerometer and gyroscope interfaces can be incorporated into the flight controller hardware.
Can you add GPS and compass interfaces?
Yes. GPS/GNSS and magnetometer interfaces can be included where required.
Can you add CAN, UART, I2C and SPI?
Yes. Required communication buses can be incorporated according to the hardware architecture.
Can you design Pixhawk style hardware?
Yes. I can design custom flight controller hardware with similar functional interfaces, but the exact architecture will depend on your project requirements.
Does the gig include ArduPilot firmware configuration?
The main service is PCB and hardware engineering. Firmware configuration, parameter setup and software development can be discussed separately.
