I will do pcb design schematic, layout for electronics and embedded board, 3d cad model

Need a manufacturing-ready PCB? You're in the right place.

I'm a certfied electronics engineer delivering full-service PCB design from blank page to Gerbers your fab house accepts on the first try.

What you get:

• Schematic capture with proper nets, decoupling, and design-for-manufacturing rules
• Multi-layer PCB layout with clean routing, controlled impedance where needed, and solid ground planes
• Gerbers, drill files, BOM, and CPL ready for JLCPCB, PCBWay, or your preferred fab
• 3D render and DRC/ERC-clean project files

Specializations:

• MCU boards (ESP32, ESP32-S3, RP2040, STM32)
• Power electronics and BMS (multi-cell, balancing, protection)
• Mixed-signal and moderate high-speed (USB, RMII, differential pairs)
• Wearables and compact handhelds where space is tight

Tools: KiCad, Altium Designer, OrCAD your choice.

Why me: Every board I deliver goes through a documented review: schematic audit, DRC pass, BOM/CPL cross-check against fab capabilities. No surprises at assembly.

Message me with your requirements rough specs, sketches, or existing files all work and I'll send back a scope and timeline within hours.